15
2020-05
Carbon fiber is a new type of fiber material with high modulus fiber with a carbon content of more than 95%.If carbon fiber is to be popularized in the automotive field, two problems need to be solved, one is cost, and the other is recycling.As the production technology continues to mature, it is believed that the production cost of carbon fiber will continue to decrease.In addition to raw...
14
2020-05
After adjusting the vertical direction, the detection data of each point has changed, and the position should be reset to zero again, and the data of the other two points should be measured again.After adjustment, you only need to check whether the sum is within the allowable error range.The principle of coupling alignment is to approximate the projection of the movable end face circle of the motor on the fixed end face as a perfect circle.
13
2020-05
1. How to use gears to change the speed? 2. When the space is limited, the transmission ratio is fixed, the distance between the motor and the power shaft, and the gear cannot match the center distance, how to deal with it? 3. How to greatly change the transmission ratio when space is limited? 4. How about a motor...
12
2020-05
Therefore, the use of diaphragm couplings is very common nowadays. The key reason is that it can exert a very stable application effect in the whole process of application, and it is more idealized and highly sensitive in hardware and machinery at this stage. , It has good practical maintenance effects for all kinds of machinery and equipment, especially...
11
2020-05
The gear coupling is composed of internal gears with the same number of teeth and flange half couplings with external teeth. The gear coupling is based on the spur gear coupling, digesting and absorbing foreign advanced The developed new gear coupling.It is composed of an external gear sleeve with a drum-shaped tooth thickness and an internal gear ring matched with it.
08
2020-05
In a car with front-engine rear-wheel drive (or all-wheel drive), due to the deformation of the suspension during the movement of the car, there is often relative movement between the input shaft of the drive shaft final drive and the output shaft of the transmission (or transfer case). In addition, to avoid certain mechanisms or devices (cannot achieve linear transmission), there must be a kind of equipment..
07
2020-05
For the sustainable development of society, environmental regulations related to automobiles are being strengthened day by day, and low fuel consumption and electrification are continuing to advance.Compared with the previous use conditions, in addition to rotating, the use of shaking state will gradually increase.In a shaking environment, the distance between the raceway of the bearing and the rolling elements is due to micro...
06
2020-05
The high-end production process of diaphragm couplings can guarantee quality and quantity, especially in the application of diaphragm couplings manufactured by Guangzhou Linko. The actual effect is more extreme. Because the manufacturer's production technology is very high-end, it can be in line with reality. The requirements of Shanghai Volkswagen customers.The key is to say that the design is simple...
29
2020-04
The turning tool is arranged on the processing platform and between the processing spindle and the positioning structure.After the friction welding is completed, the temperature at the joint of the shaft is relatively high. The turning tool is used to directly remove the welding residual material to avoid the impact on the accuracy of the shaft due to the heat change during the cooling process, and the turning is performed when the temperature is high. by..