31
2019-08
In four-wheel drive (4WD) vehicles, the drive shaft is installed between the transmission output shaft and the drive axle final drive input shaft, and is responsible for transmitting the power of the engine to the rear wheels, and driving the car forward through the four wheels to make the vehicle better The passability and adhesion.Rubber mounting seat with high resistance to muddy water, should...
23
2019-08
According to the type, it is divided into the following common categories: Metal diaphragm coupling: suitable for servo motors, encoders, planetary reducers, ball screws, compressors, mixers, paper machinery, robots and other mechanical equipment.Plum blossom coupling: suitable for encoders, servo systems, motor spindle drive, packaging machinery, machine tool transmission...
05
2019-08
In a four-wheel drive (4WD) vehicle, the drive shaft is installed between the transmission output shaft and the drive axle final drive input shaft, and is responsible for transmitting the power of the engine to the rear wheels, and driving the car forward through four wheels to make the vehicle better The passability and adhesion.Check whether the rubber gasket ring of the middle support is cracked,...
15
2019-07
The elastic coupling is parallel grooved. The elastic coupling is a one-piece metal elastic body, usually cut from a metal round bar. The commonly used materials are aluminum alloy, stainless steel, and engineering plastics, which are suitable for various deviations and transmission torques. .For occasions where the load starts frequently or the working load changes, the coupling needs...
31
2019-05
The heat treatment method of high temperature tempering after quenching is called quenching and tempering treatment.High temperature tempering refers to tempering between 500-650°C.Quenching and tempering can make the performance and material of steel be adjusted to a large extent, and its strength, plasticity and toughness are good, and it has good comprehensive mechanical properties.Tempered after quenching and tempering..
20
2019-04
The flexible coupling has strong flexibility, so it allows the connected rotor to have a relatively large eccentricity and is not sensitive to the transmission of vibration. However, due to the complex structure, the transmitted torque is also small, and it is generally used in small units.The semi-flexible coupling allows a certain eccentricity between the connected rotors, and allows two connected...
11
2019-04
Symptom diagnosis: When a 6×4 car is under heavy load, especially when driving bumps, it occasionally makes a knocking sound. Pay attention to check whether the balance shaft of the middle and rear axle is displaced and interferes with the transmission shaft.If the noise increases with the speed of the car, and there is jitter, this is generally caused by the loss of balance of the transmission shaft. ..
27
2019-03
The drive shaft is a high-speed rotating body with less support, so it is very important for dynamic balance.Generally, the drive shaft undergoes a balance test before leaving the factory and is adjusted on a balance machine.For the front-engined rear-drive car, the steering final drive shaft is driven, and the parts can be connected by universal joints.Special purpose car:
13
2019-03
SWC type cross-shaft universal coupling is suitable for steel rolling machinery, hoisting and writing and other heavy machinery, connecting two shafts that are not on the same line, its rotation diameter D=100~1200mm, transmission nominal torque Tn=1.25~8000KN .m, the power of heavy load at high speed..