02
2020-04
Taking into account the end effect, a three-dimensional calculation model of the magnetic coupling was established on the basis of the traditional two-dimensional magnetic field solution analysis, and the ANSYS software was used to simulate and analyze the three-dimensional model. The total magnetic induction intensity distribution and the magnetic field intensity distribution at the air gap were obtained. Etc., and KTR's three-dimensional simulation of the magnetic coupling..
01
2020-04
A screaming noise from the drive shaft of a car.Although the abnormal noise can not be heard at any time, but when the car shifts reverse gear or forward gear, it will repeatedly make a light bumping sound.Solution: The common cause of abnormal noise of the drive shaft is a bad universal joint.When the universal joint is worn out, it will make a scream.The screaming noise is due to Wan...
30
2020-03
The drum gear coupling has a continuous multi-turn long slot. This coupling has excellent elasticity and a small bearing load. It can withstand deviations and is more suitable for correcting deflection and axial deviation , But the ability to deal with eccentricity is relatively poor, because it is necessary to bend the spiral groove in two different directions at the same time..
27
2020-03
Diaphragm coupling mother body manufacturing.The choice of the matrix material of the diaphragm coupling is very important. Generally, the 45# or 40CR forging material should be selected and the rough machining should be carried out after the normalizing treatment. After the rough machining, the quenching and tempering treatment should be carried out to form the overall machine of the coupling material. The performance reaches its performance state, and the quality is...
24
2020-03
After the current is disconnected, the magnetic powder quickly restores the non-excited state, releases the control of the clutch, and quickly restores the off state.Through the control of current, multiple functions of overload protection, clutch, no-load drive, torque adjustment, speed control, tension control, position control and commutation are realized.Torque control range:
20
2020-03
Metal diaphragm coupling (lightweight aluminum alloy single diaphragm) ·No backlash, synchronous operation, dedicated for high-precision occasions such as servo motors, stepping motors, encoders, etc.·High rigidity and can absorb large installation errors·Specially made Aluminum alloy material, low inertia, clamping connection, metric or inch size aperture..
16
2020-03
The role of drive shafts in auto parts is still very powerful and should not be underestimated.In a car with front-engine rear-wheel drive (or all-wheel drive), due to the deformation of the suspension during the movement of the car, there is often relative movement between the input shaft of the drive shaft final drive and the output shaft of the transmission (or transfer case). this..
13
2020-03
如果是Y型轴孔的话,根据轴孔直径的大小分别有62mm、82mm、112mm 三种长度;如果是J J1型轴孔的话,根据轴孔直径的大小分别有44mm、60mm、82mm三种长度。 轴配合的毂孔长度简..
11
2020-03
If the coupling has any deviation in the system, it will cause premature damage to the shaft, bearing or coupling, which means that it cannot be used in a high-speed environment because it cannot compensate for the high temperature caused by high-speed operation. Relative displacement between shafts.Of course, if the relative displacement can be successfully controlled, in the servo system..