Welcome to the website of Hangzhou Hengli Transmission Co., Ltd.; it mainly produces universal coupling series and transmission shaft series products.
28
2019-12
There are three types of shaft holes for couplings: Y-type, J-type, and Z-type. Y-type shaft hole is a long cylindrical shaft hole, J-type shaft hole is divided into J type and J1 type, J type is a short cylindrical shaft hole with counterbore, and J1 type is a short cylindrical shaft hole without counterbore. Z type shaft hole is divided into Z type and Z1 type, Z type is a short circle with counterbore..
27
2019-12
The main elastic drum gear coupling of the elastic coupling is the rubber component that changes the load. The rubber component can be planned into single row or multiple rows. Each rubber component has a variety of standard stiffnesses to choose from, which can be twisted satisfactorily on a large scale. Vibration calculation confirmed the stiffness requirements, drum-shaped gear coupling.Used in ship power system..
24
2019-12
Choosing a coupling for a servo system is a complicated process. This process needs to consider requirements such as torque, relative displacement of the shaft, hardness, speed, and size.In order to ensure the normal operation of the coupling, these requirements must be very matched.Before selecting couplings, perform the performance and application details of these couplings..
23
2019-12
The diaphragm coupling can actively compensate the axial, radial and angular offset caused by the motor, as well as the influence caused by factors such as manufacturing error, installation error, bearing deformation and temperature rise.The diaphragm coupling belongs to the metal elastic element in the flexible coupling. The driven machine transmits torque, elastic vibration, no noise, and no lubrication..
19
2019-12
For a front-rear-drive car, the torque from the engine is transmitted to the rear wheels through the clutch, gearbox, universal joint, drive shaft, final drive, differential, and half shaft in turn, so the rear wheel is also called Drive wheel.The torque obtained by the driving wheel gives the ground a backward force, and therefore the ground is driven..
16
2019-12
Before installation, first check whether the prime mover and the working machine are concentric, whether there are wrapping paper and scratches on the surfaces of the two shafts, whether there are debris in the inner holes of the two half couplings of the plum coupling, and whether the edges of the inner holes are bumped. If any, the shaft and half coupling should be cleaned up, and the bruise should be treated with a fine file.Then check the two and a half...
13
2019-12
When we received this feedback in the early stage, we were also very surprised. As a universal joint shaft manufacturer with more than ten years of experience, judging from the design structure of our cross bag, there will be no situation where oil cannot be added. In addition, we are Before the product is assembled and shipped, the bearings in the four directions of the cross bag will be filled with grease, so that..
11
2019-12
(1)中间支撑吊架螺栓孔与螺栓配合间隙过大。 (2)车架变形。 (3)传动轴不平衡量过大。 (4)中间支撑吊架橡胶垫老化或质量太差。 (5)支架总成质量问题 . (6)检查带伸宿的配件没..
10
2019-12
The main feature of the elastic pin coupling is to drill holes in the flange, and nylon rods or threaded pins are worn inside.However, the flange holes must be interchanged to ensure the service life of the coupling.There are three types of shaft-hole interchangeable fits, depending on the application of your shaft and hole. Clearance fit; relative motion transitional fit: between relative motion...
Contact: Jack
Consulting Hotline: 13756967288
Landline: 0523-86855968
Address: Xihu District, Hangzhou