Welcome to the website of Hangzhou Hengli Transmission Co., Ltd.; it mainly produces universal coupling series and transmission shaft series products.
11
2019-10
Since the coupling and other products are used in different host products, the working environment is a bit complicated and will be affected by temperature, water, dust and other aspects.When choosing coupling, you should consider these aspects according to your actual situation.In some cases, the accuracy requirements are different.Let's do well...
27
2019-09
The failure of the universal joint of the drive shaft bracket is mainly due to the wear of the journal and the bearing and the bending and deformation of each journal, which causes the center lines of the cross shafts to be not on the same plane, or the center lines of two adjacent shafts are not vertical.As the universal joint cross shaft journal and bearing wear gap is too large, the cross shaft shakes during operation, which makes the transmission...
19
2019-09
Use a ruler to measure the coaxiality error of the coupling, and use a plug gauge to measure the parallelism error of the coupling.This method is simple, but the error is large.Generally used for machines with low speed and low precision requirements.Use two dial gauges to measure the values on the outer circle and end face of the coupling hub respectively, and the measured values...
09
2019-09
Use the extruder and workbench equipment to install the universal joint on the flange fork, and then install the universal joint fork on the universal joint; the second step: Part B assembly: use the extruder and workbench equipment on the flange Install the universal joint on the fork, and then install the spline shaft fork and spline hub sub-assembly or sliding fork and rear axle head sub-assembly on the universal joint; ..
31
2019-08
In four-wheel drive (4WD) vehicles, the drive shaft is installed between the transmission output shaft and the drive axle final drive input shaft, and is responsible for transmitting the power of the engine to the rear wheels, and driving the car forward through the four wheels to make the vehicle better The passability and adhesion.Rubber mounting seat with high resistance to muddy water, should...
23
2019-08
According to the type, it is divided into the following common categories: Metal diaphragm coupling: suitable for servo motors, encoders, planetary reducers, ball screws, compressors, mixers, paper machinery, robots and other mechanical equipment.Plum blossom coupling: suitable for encoders, servo systems, motor spindle drive, packaging machinery, machine tool transmission...
05
2019-08
In a four-wheel drive (4WD) vehicle, the drive shaft is installed between the transmission output shaft and the drive axle final drive input shaft, and is responsible for transmitting the power of the engine to the rear wheels, and driving the car forward through four wheels to make the vehicle better The passability and adhesion.Check whether the rubber gasket ring of the middle support is cracked,...
15
2019-07
The elastic coupling is parallel grooved. The elastic coupling is a one-piece metal elastic body, usually cut from a metal round bar. The commonly used materials are aluminum alloy, stainless steel, and engineering plastics, which are suitable for various deviations and transmission torques. .For occasions where the load starts frequently or the working load changes, the coupling needs...
31
2019-05
The heat treatment method of high temperature tempering after quenching is called quenching and tempering treatment.High temperature tempering refers to tempering between 500-650°C.Quenching and tempering can make the performance and material of steel be adjusted to a large extent, and its strength, plasticity and toughness are good, and it has good comprehensive mechanical properties.Tempered after quenching and tempering..
Contact: Jack
Consulting Hotline: 13756967288
Landline: 0523-86855968
Address: Xihu District, Hangzhou