Welcome to the website of Hangzhou Hengli Transmission Co., Ltd.; it mainly produces universal coupling series and transmission shaft series products.
27
2019-11
In mechanical transmission, power machines are nothing more than electric motors, internal combustion engines and steam turbines. Due to the different working principles and structures of power machines, their mechanical characteristics are very different. Some run smoothly, and some have shocks during operation, which have unequal effects on the transmission system. , The mechanical characteristics of the power machine have certain effects on the entire transmission system..
27
2019-11
The elastic coupling contains an elastic compound of pre-compressed rubber to provide additional strength and extend service life.The coupling can accommodate all types of deviations.The wheel hub is made of high-strength aluminum alloy, which is both lightweight and corrosion-resistant.Among them, the rubber component is mainly used for shock absorption, so that the power transmission is smooth and quiet, so as to protect...
21
2019-11
The shape of the dust cover of the drive shaft is like the wrinkled part of the neck of the "sipper".Generally, when we pull out the neck of the straw, if you pull it too hard and pull it out in an instant, it may cause the wrinkle to break. Therefore, when the drink is inhaled, the drink will leak and cannot be sucked out. ..
21
2019-11
The drive shaft is a rotating body with high speed and less support, so its dynamic balance is very important.Generally, the drive shaft must undergo a dynamic balance test before leaving the factory and be adjusted on a balance machine.For a front-engine rear-wheel drive car, it is good to transfer the rotation of the transmission to the shaft of the final drive..
14
2019-11
The torque transmission of the coupling is mainly to set the nominal torque requirement of the transmission system. In the case of overload, the torque transmission element is separated from the two halves of the coupling to realize the protection of the transmission system at both ends of the main shaft.The material form of the coupling is roughly divided into profiles (round steel), castings (cast iron...
14
2019-11
It adopts a mechanically enclosed structure (commonly known as a square machine), continuous hydraulic loading and variable frequency drive, which saves power consumption. In order to simulate the actual installation angle requirements of the car, the drive ends on both sides adopt a horizontal slewing mechanism, and the middle transmission device adopts up and down movement. The mechanism can be adjusted arbitrarily.There are hands on the drive ends on both sides..
07
2019-11
After the intermediate support bearing of the drive shaft is used for a short time, phenomena such as pitting, peeling, or even falling apart will occur, which will cause the drive shaft to tremble and other faults. The main reason for this failure is the incorrect installation position of the intermediate support bearing. Deviation from the original design requirements, in addition to bearing the transmitted force when rotating the force..
29
2019-10
The drive shaft must undergo a dynamic balance test before leaving the factory and be adjusted on a balancing machine.For a front-engine rear-wheel drive car, the rotation of the transmission is transmitted to the shaft of the final reducer. It can be several sections, and the sections can be connected by universal joints. 1. First, drill the center hole at both ends of the forging blank...
21
2019-10
Generally speaking, the elastic pin is used on the TL-type elastic sleeve pin cardan shaft, which mainly plays the role of driving the two half couplings to fix and transmit.And whether the hardness of the pin will change the torque of the cardan shaft, for the standard data, the fixed number, size and material of the backrest pin will not change the torque too much..
Contact: Jack
Consulting Hotline: 13756967288
Landline: 0523-86855968
Address: Xihu District, Hangzhou