05
2020-11
1) Single-sided unbalanced state If the center of gravity of the object is not on the axis of rotation, a single-sided unbalanced state will appear.At this time, regardless of the relative position between the object and the axis, it will not be in a static equilibrium state.Place the journal of the unbalanced object on two parallel horizontal rods or guide rails, and you can observe the single...
26
2020-10
There are two types of drive shaft suspension rubber suspension bearings, one is single-sided rubber, and the other is double-sided rubber. Rodeo's loading parts are double-sided, and pickups are single-sided, but Rodeo's later repairs and replacements are both useful, and parts sellers often use single-sided pickups to charge.The car drive shaft hanging rubber hanging can be heard from the sound..
23
2020-10
The correct use of universal couplings can prolong the life. It is strictly forbidden for the car to start at high gear; it is strictly forbidden to lift the clutch pedal; it is strictly forbidden to overload or overspeed the vehicle; check the working condition of the transmission shaft; check the tightening of the transmission shaft hanger frequently , Whether the supporting rubber is damaged, whether the connecting parts of the drive shaft are loose..
13
2020-10
In the case of abnormal noise and vibration, check whether the expansion joint is installed on a standard scale. When it is installed correctly, support the car body, start the engine, and run at idle speed. When the vibration of the cardan shaft is large, use a stylus to measure the direction of the vibration part And the transmission amount. When the two ends of the transmission shaft are not straight or bent, if the cardan shaft is obviously concave..
12
2020-10
1. Keyway type (DJM diaphragm elastic coupling): Its key width and keyway are specified by the national standard GB/T1095-2003, and there are three different tolerance ranges for loose key connection, general key connection, and tighter key connection. The transmission suitable for high torque can be selected..
08
2020-10
Gear couplings have a wide range of applications and are used in many industries.It may be improperly used in specific situations, or it may be used without consideration, which will also cause the coupling to be damaged during use.Gear couplings are rigid, flexible, and inelastic, so...
28
2020-09
The universal joint is a key component on the drive shaft of an automobile.On rear-wheel drive vehicles, the universal joint drive shaft is installed between the transmission output shaft and the drive axle input shaft; while the front-wheel drive vehicle omits the drive shaft and the universal joint is installed on the front axle and wheels that are responsible for both driving and steering. between.The car is a sporty...
23
2020-09
The mechanical structure that uses the ball connection to realize the power transmission of different shafts is a very important part of the bearing on the automobile.The front-engine front-wheel drive vehicle omits the transmission shaft, and the universal joint is installed between the front axle half shaft and the wheels that are responsible for driving and steering.On a front-engine rear-wheel drive vehicle...
15
2020-09
The reasons for bearing heating may be: 1. Rolling bearing: insufficient lubrication of the bearing; the location (shaft or hole) where the bearing is installed is different from the shaft; and improper selection of the bearing model, etc. 2. Sliding bearing: insufficient lubrication of the bearing; improper matching seat of the bearing; improper selection of the material of the bearing pair;