Welcome to the website of Hangzhou Hengli Transmission Co., Ltd.; it mainly produces universal coupling series and transmission shaft series products.
26
2020-03
The end of the drive shaft is connected by a flange with an ear fork. Due to its simple structure, it is easy to manufacture and assemble. It is a kind of connection form adopted.According to the centering method, there are two types: inner circle centering and outer circle centering; depending on the way of force transmission, there are rigid transmission and friction transmission.Comes with a single universal...
25
2020-03
For general bracket parts, it is completely reasonable to use the opposite surface of the bracket bottom surface as the rough reference.But for this part, if the opposite surface of the bottom of the bracket is used as the rough reference.Therefore, in accordance with the selection principle of the rough reference (that is, when the part has an unprocessed surface, these unprocessed tables should be used..
23
2020-03
In the process of driving, a car will inevitably encounter rough and uneven road conditions. This kind of road conditions will cause the car to jump and the load will change. Then the output shaft of the transmission and the input shaft of the final drive will be clamped between the output shaft of the transmission and the input shaft of the final reducer. The angle and distance will change accordingly.At this time, the drive shaft's ten thousand...
21
2020-03
The gear coupling is composed of two halves, which are respectively connected with the driving shaft and the driven shaft.Generally, the power machine is mostly connected with the working machine by means of a gear coupling.As long as the shaft is connected to the shaft, gear couplings are almost always used.For the application of gear couplings, under normal circumstances, as long as there is a motor or reducer, it will be used..
19
2020-03
After the intermediate support bearing of the drive shaft is used for a short time, phenomena such as pitting, peeling, or even falling apart will occur, which will cause the drive shaft to tremble and other faults. The main reason for this failure is the incorrect installation position of the intermediate support bearing. Deviation from the original design requirements, in addition to bearing the transmitted force when rotating the force..
18
2020-03
The design of the diaphragm coupling is relatively simple, and it can give full play to good practical effects in the whole process of application, and there is no need to apply lubricating fluid, so it can exceed the more convenient specifications at the time of maintenance. Naturally, it is possible to consider the application regulations of a variety of different manufacturing industries, yes..
17
2020-03
The unbalanced torque of the motor during start-up and operation will easily cause radial vibration of the current collecting equipment, which may cause uneven brush wear and shorten the service life of the brush; at worst, the collector ring and the brush will ignite due to poor contact. , Ablate the surface of the collector ring, and even damage the collector's diaphragm coupling; in the normal condition of the sensor equipment..
14
2020-03
The pin coupling has the ability to compensate for the relative offset of the two shafts and reduce vibration and conflict.The elastic sleeve is a compression deformation. Because the thickness of the elastic sleeve is thin and the elastic deformation is limited, although the elastic sleeve pin coupling can repay the axis displacement and elasticity, the allowable repayment amount of the axis displacement is less and the elasticity is weak.elasticity..
12
2020-03
Tighten the front wheel of the car with mats, jack up the middle and rear drive axles on one side of the car; start the engine, put it in high gear, and observe the vibration of the drive shaft.During the observation, notice that when the speed drops, if the shimmy increases significantly, it indicates that the drive shaft is bent or the flange is skewed.The bending of the drive shaft is the bending of the shaft tube, most of..
Contact: Jack
Consulting Hotline: 13756967288
Landline: 0523-86855968
Address: Xihu District, Hangzhou