1.A connecting link of an O-ring Chain for basic application is pre-coated with grease in the pins. Prior to connection, confirm the grease to the surfaces of pins, and in the event the quantity of grease is small, apply grease with bare hands. (If gloves are made use of, the grease will likely be absorbed through the gloves.)
Example: When the connecting website link (I) of an O-ring chain for common application is
shipped, O-rings are fitted at the roots of the pins. In case the O-rings come loose as a result of vibration throughout transport, refit the O-rings in to the roots on the pins.
In this case, you should definitely return the grease collected in the roots with the pins to your central surfaces of your pins, more at portion A than at portions B shown inside the over illustration. (Portions A is worn as a consequence of sliding with the bushings.)
2.The chain can be most quickly connected within the teeth of the sprocket. Engage the links at both ends with the chain using the sprocket teeth and match connecting pins. In case the sprocket might be moved, the chain may also be connected around the loosened side.
3. Connecting method
1.Confirm that O-rings are connected for the roots on the pins.
2.Should the quantity of grease applied to the connecting pins is tiny, coat the pins with grease on the central portions.
three.Insert the connecting pins in to the bushings on the inner back links at the two ends.
4.Verify that the grease is applied on the entire face on the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and although pressing the connecting plate, set up the spring clip. Confirm no matter whether the head (the finish with no split) with the spring clip is turned within the feeding route of the chain. (See the next illustration.)
six.Be sure to confirm the spring clip is securely fitted in the clip grooves of your connecting pins.
This completes 
jointing of the connecting hyperlink. Note that grease within the surfaces of connecting pins and O-rings can be removed through installation function. In this case, re-grease using the grease to the surface of your base chain or even the grease during the polyethylene bag through which the connecting hyperlink was contained.
